INTRODUCTION:

• OSCILLOSCOPE
  

• Define the following terms Accuracy, Precision, Sensitivity, Resolution, error and range.
• Name factors to consider while conducting measurements.

• Describe the function and operation of the cathode ray tube, horizontal deflection, delay sweep, vertical deflection, and explain the differences between the alternate & chopped mode in a dual trace oscilloscope.

PHASE MEASUREMENT WITH OSCILLOSCOPE:

FREQUENCY MEASUREMENT WITH OSCILLOSCOPE:

• Explain how both the sweep method & lissajous pattern can be used to measure the phase shift between two waveforms of the same frequency.
• Describe how rise and fall time measurements are made using an oscilloscope
  
  
• Explain how frequency is measured using both the time-based & lissajous-pattern methods

OSCILLOSCOPE PROBES & NOISE PICK-UP:

• Describe the function & characteristics of oscilloscope probes and how to use square wave as a test signal.
• Describe how interference arises from electromagnetic sources.
  

DC BRIDGES

• Wheatstone bridge
• Kelvin bridge
  
  

• Determine unknown resistance's using either a Wheastone or Kelvin bridge.
  

MEASUREMENT OF CAPACITANCE & INDUCTANCE:

• Determine unknown capacitance & inductance using AC-bridge and identify & compare the characteristics of measuring capacitance with series resistance & parallel resistance.
• Identify & compare the characteristic of measuring inductance with the Maxwell & Hay bridge.
• Use a Q-meter to measure Q-factor & inductance.
  
  

AC-VOLTMETER & DISTORTION ANALYZER:

• Describe the operation of average RMS & peak responding voltmeters.
• Explain how to correct meter readings for waveform other than sine wave.
• Describe & use distortion analyzer
  
  

DIGITAL VOLTMETER:

• Describe how a digital voltmeter works in terms of V/F converter.
• Compare the advantage of digital & analog meter.
  
  

ANALOG & DIGITAL STORAGE OSCILLOSCOPE:

• Describe the operation of analog & digital storage oscilloscope.
• Use the digital storage oscilloscope for low frequency signal measurement.
  
  

LOGIC ANALYZER:

• Explain the purpose & operation of a logic analyzer.
• Discuss the trigger modes of a logic analyzer.
• Define qualifier lines, trigger delay, word event delay & clock delay.